Installation & Testing

Installation

Hi-Line Safety Systems are able to install Fall / Restraint systems on any roof type from:

  • Single ply Membrane
  • Concrete
  • Metal composite panels ( 5mm to 7mm )
  • Standing & Seam panels
  • Tile or Slated roof

 

Using a wide and varid range of installation methods from:

 

  • Toggle fix for Single ply membrane
  • Studding and  Chemical Resin for concrete fixings.
  • Rivets specified by our suppliers Kee safety for metal composite panels
  • Clamp fittings using grub screws to secure to Standing & Seam roof panels.
  • Kee Anchor for installations to rafters,  joist`s & ridges.

 

We can install on roof pitchs from:

 

  • 0 to 45 degrees

 

We can offer Non-penitrating systems on roof types such as:

 

Dead weight anchor System on the below roof types on a pitch 0-5 Degress

 

  • Single Ply Membrane Asphalt
  • Steel Cladding Concrete
  • Stone Chippings (Brushed)
  • Mineral Felt

We have a solution for every roof type from domestic homes  to commercial propertys such as, Warehouse`s,  Schools, Office blocks, business centers, Hotels.

 

Should you wish for any insurance documents please feel free to ask as we have £10,000,000 for both public and employers liability cover.

 

Testing

We are able to offer an inspection service offered on an annual basis for new and existing safety equipment, we will carry out an inspection on all equipment that you have installed and make sure that you are fully compliant with with current Health and Safety legislation regarding working at heights & National and European design Standards.

 

The most common safety equipment found on most propertys would vary from, Fall Arrest / Restraint Safety Lines, Eyebolts, push locks, Ladder Ties, Guradrail, Roof Edge Protection & P.P.E (Personal Protection Equipment ). All of which MUST be tested by a trained and competent person on an annual basis.

 

In Addition we offer a full working at height assesment service to your roof top areas.  We will inspect & issue a full report indicatiing the potentual safety hazards & provide you with our recommendations on solutions to overcome future hazards and potential injuries.

 

Whilst we are on the roof we will be making a general assesment of the roof condition and will report back to the client any damage we have noticed that could potentually cause further damage should it be not addressed by the appropiate contractor such as, loose panels, blocked gutters, leaking roofs and  if possible we will make a tempory fixing to the roof untill a contractor can be on site.

We will also take thumb nail photos of the safety equipment to add to the report so you can have a greater understanding of the equipment that is on site. which will also include the full roof report.

Print Print | Sitemap
© Hi-Line Safety Systems Ltd